No one is probably trying to even do this anymore due to the new Dell switching lines, but thought I would see if I could help. Global extended information enabled: noneĬollector IP addr:10.10.5.152 Agent IP addr:10.10.5.246 UDP port:2050 VRF:Defaul t Global default extended maximum header size: 128 bytes Global default counter polling interval: 30 Management Interface sFlow services are disabled You can confirm that by running the following command: Then you have to specify the physical interfaces you want to send Sflow traffic. In this example these commands used to setup Sflow on a Dell S4128F-ON running 10.4.2.0.226. These commands should be all that is needed to setup Sflow on OS10. Now lets see if the switch was updated with the “show version” command.
The firmware took a few minutes to install, with about 4 reboots I think – it was all automatic. The onie-nos-install will install the OS back to the device.
Next I put this on my TFTP server and we can start the install.įirst lets turn off the ONIE-Discovery attempts with the onie-stop command. In this case the file name is onie-installer-x86_64-dellemc_n22xx_6.6.3.10. This file is located in the software archive you download from Dell – Its located in the Perfect! My laptop is 192.168.1.99 – and connected directly to the out of band MGMT port. TX packets:49 errors:0 dropped:0 overruns:0 carrier:0 RX packets:108 errors:0 dropped:0 overruns:0 frame:0 We should be able to set an IP address on the interface and install firmware VIA TFTP or USB.įirst I will setup and IP that can communicate with my laptop : Eth0 is the out of band management interface. Great! Eth0 is found, but of course link status is down. TX packets:13 errors:0 dropped:0 overruns:0 carrier:0 RX packets:67 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 First check out your NIC to make sure it finds it:Įth0 Link encap:Ethernet HWaddr 8C:47:BE:97:B5:0F The ONIE recovery area runs a version of Linux.
The device was boot looping – the only option was to drop into ONIE Recovery and re-install the firmware. Somehow it did not and hosed both primary/secondary firmware. We upgraded firmware to the latest 6.6.3.10 and all seemed to go well. I have been working a lot with the Dell N-series over last few years, and now the N2248-ON which can run OS10 as well as the default OS6.
0 kommentar(er)
